Standard
Historical
Last Updated: Jan 17, 2022
Track Document
ASTM D7878/D7878M-13e1
Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type, Size Range 00P – 20P (Withdrawn 2022)
Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type, Size Range 00P – 20P (Withdrawn 2022)
D7878_D7878M-13E01
ASTM|D7878_D7878M-13E01|en-US
Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type, Size Range 00P – 20P (Withdrawn 2022)
Standard
D7878/D7878M Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type, Size Range 00P – 20P (Withdrawn 2022)>
new
BOS Vol. 07.02 Committee D13
$
86.00
In stock
ASTM International
Significance and Use
4.1 The use of the body measurement information in Tables 1 and 2 will assist manufacturers in developing patterns and garments that are consistent with the current anthropometric characteristics of the population of interest. This practice should in turn reduce or minimize consumer confusion and dissatisfaction related to apparel sizing. (Also refer to ISO 3635 Size Designation Procedures.)
4.2 Three-dimensional avatars depicting each of the Misses Petite sizes and sub categories Curvy and Straight on certain measures were created by Alvanon, Inc. and included in this standard to assist manufacturers in visualizing the posture, shape, and proportions generated by the measurements charts in the accompanying Tables5 (Avatar 1-6) (see Figs. 1 and 2).
Scope
1.1 These tables list body measurements of adult female misses petite figure type sizes 00P through 20P. Although these are body measurements, they can be used as a baseline in designing apparel for Misses Petite in this size range when considering such factors as fabric type, ease for body movement, styling, and fit.
1.2 These tables list body measurements for the complete range of misses petite sizing.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.