Standard
Active
Last Updated: Jan 23, 2023
Track Document
ASTM C1216/C1216M-23
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
C1216_C1216M-23
ASTM|C1216_C1216M-23|en-US
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
Standard
C1216/C1216M Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants>
new
BOS Vol. 04.07 Committee C24
$
72.00
In stock
Significance and Use
4.1 The failure of a building sealant in a joint that experiences movement is manifested by cohesive failure in the sealant or adhesive failure between the sealant and substrate, or both. This test method evaluates the performance of one-part elastomeric solvent release sealants in joints subjected to movement and temperature aging.
Scope
1.1 This test method is a laboratory procedure that determines the adhesion and cohesion performance of one-part elastomeric, solvent release sealants at high and low temperatures by the extension and compression of test specimens.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 The subcommittee with jurisdiction is not aware of any similar ISO standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 2.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.