Standard
Historical
Last Updated: Jan 13, 2022
Track Document
ASTM C1216/C1216M-13
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants (Withdrawn 2022)
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants (Withdrawn 2022)
C1216_C1216M-13
ASTM|C1216_C1216M-13|en-US
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants (Withdrawn 2022)
Standard
C1216/C1216M Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants (Withdrawn 2022)>
new
BOS Vol. 04.07 Committee C24
$
86.00
In stock
Significance and Use
4.1 The failure of a building sealant in a joint that experiences movement is manifested by cohesive failure in the sealant or adhesive failure between the sealant and substrate, or both. This test method evaluates the performance of one-part elastomeric solvent release sealants in joints subjected to movement and temperature aging.
Scope
1.1 This test method is a laboratory procedure that determines the adhesion and cohesion performance of one-part elastomeric, solvent release sealants at high and low temperatures by the extension and compression of test specimens.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 2.