There is no PDF download available at this time. Please contact customer service.
Standard
Withdrawn, No replacement
Last Updated: Feb 03, 2026
Track Document
ASTM C1181/C1181M-17
Standard Test Methods for Compressive Creep of Chemical-Resistant Polymer Machinery Grouts (Withdrawn 2026)
Standard Test Methods for Compressive Creep of Chemical-Resistant Polymer Machinery Grouts (Withdrawn 2026)
C1181_C1181M-17
ASTM|C1181_C1181M-17|en-US
Standard Test Methods for Compressive Creep of Chemical-Resistant Polymer Machinery Grouts (Withdrawn 2026)
Standard
C1181/C1181M Standard Test Methods for Compressive Creep of Chemical-Resistant Polymer Machinery Grouts (Withdrawn 2026)>
new
BOS Vol. 04.02 Committee C09
$
0.00
Out of stock
ASTM International
Significance and Use
4.1 These test methods provide a means of measuring the total compressive deflection of chemical-resistant, machinery-grout materials under a sustained load at the test temperature. Test stress and temperature can be selected to simulate anticipated use conditions. For the purposes of these tests, creep is considered to be the compressive deflection in cm per cm [inches per inch], which occurs after the initial loading of the specimen at laboratory temperature. The results do not necessarily correlate for different specimen thicknesses. No correlation has been established to actual-use conditions.
Scope
1.1 These test methods cover a quantitative, comparative test for compressive creep of chemical-resistant grouting materials under a sustained load at a test temperature. Constant load is maintained using a bolt and spring washers. Measurements are made at laboratory temperature after exposure periods at the selected test temperature.
1.2 Test Method A outlines the molding techniques for an unbonded test specimen. Test Method B covers the molding techniques for a bonded test specimen.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.