Standard
Historical
Last Updated: Nov 12, 2012
Track Document
ASTM B470-02(2007)
Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment
Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment
B0470-02R07
ASTM|B0470-02R07|en-US
Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment
Standard
B470 Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment>
new
BOS Vol. 02.03 Committee B01
$
77.00
In stock
Abstract
This specification covers stranded uninsulated bare, tin, or tin-lead alloy coated copper conductors in which wires in the strand are metallically bonded together by the application of heat additional tin, or tin-lead alloy for use in hookup wire for electronic equipment. Conductor constructions shall conform to standard ASTM requirements except that, in addition, the following bondings may be specified: Type I, Type II, and Type III. The conductors shall consist of tinned copper and bare copper, conforming to product description, quality, and specification requirements. The material shall undergo flex, fraying, mandrel, and resistance tests. The material shall meet the minimum flex life requirements and shall conform to the required conditions for flex, fraying, and madrel tests.
Scope
1.1 This specification covers stranded uninsulated bare, tin, or tin-lead alloy coated copper conductors in which wires in the strand are metallically bonded together by the application of heat or additional tin, or tin-lead alloy for use in hookup wire for electronic equipment.
1.2 The SI values for density and resistivity are to be regarded as standard. For all other properties, the inch-pound values are to be regarded as the standard and the SI units may be approximate.
1.3 The hazard caveat pertains only to Section 6 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.