Standard
Active
Last Updated: Apr 01, 2021
Track Document
ASTM A722/A722M-18
Standard Specification for High-Strength Steel Bars for Prestressed Concrete
Standard Specification for High-Strength Steel Bars for Prestressed Concrete
A0722_A0722M-18
ASTM|A0722_A0722M-18|en-US
Standard Specification for High-Strength Steel Bars for Prestressed Concrete
Standard
A722/A722M Standard Specification for High-Strength Steel Bars for Prestressed Concrete>
new
BOS Vol. 01.04 Committee A01
$
72.00
In stock
Abstract
This specification covers uncoated high-strength steel bars intended for use in pretensioned and post-tensioned prestressed concrete construction or in prestressed ground anchors. Two types of bars are considered: Type I bar, which has a plain surface and Type II bar, which has surface deformations. The bars shall be rolled from properly identified heats of ingot cast or strand cast steel. The bars shall be subjected to cold-stressing and then shall be stress-relieved to produce the prescribed mechanical properties. Yield strength, elongation, and tension tests shall be performed.
Scope
1.1 This specification covers Type I and Type II high-strength steel bars intended for use in prestressed concrete construction or in prestressed ground anchors. Type I bars have a plain surface. Type II bars have surface deformations. Bars are of a minimum tensile strength level of 150 000 psi [1035 MPa].
1.2 A supplementary requirement (S1) is provided for use where bend tests of bars are required by the purchaser. The supplementary requirement applies only when specified in the purchase order.
1.3 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.4 This specification is applicable for orders in either inch-pound units (as Specification A722) or in SI units (as Specification A722M).
1.5 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.