Standard
Historical
Last Updated: May 16, 2012
Track Document
ASTM A722/A722M-07
Standard Specification for Uncoated High-Strength Steel Bars for Prestressing Concrete
Standard Specification for Uncoated High-Strength Steel Bars for Prestressing Concrete
A0722_A0722M-07
ASTM|A0722_A0722M-07|en-US
Standard Specification for Uncoated High-Strength Steel Bars for Prestressing Concrete
Standard
A722/A722M Standard Specification for Uncoated High-Strength Steel Bars for Prestressing Concrete>
new
BOS Vol. 01.04 Committee A01
$
86.00
In stock
Abstract
This specification covers uncoated high-strength steel bars intended for use in pretensioned and post-tensioned prestressed concrete construction or in prestressed ground anchors. Two types of bars are considered: Type I bar, which has a plain surface; and Type II bar, which has surface deformations. The bars shall be rolled from properly identified heats of ingot cast or strand cast steel. The bars shall be subjected to cold-stressing and then shall be stress-relieved to produce the prescribed mechanical properties. Yield strength, elongation, and tension tests shall be performed.
Scope
1.1 This specification covers uncoated high-strength steel bars intended for use in pretensioned and post-tensioned prestressed concrete construction or in prestressed ground anchors. Bars are of a minimum ultimate tensile strength level of 1035 MPa (150000 psi).
1.2 Two types of bars are provided: Type I bar has a plain surface and Type II bar has surface deformations.
1.3 Supplementary requirements of an optional nature are provided. They shall apply only when specified by the purchaser.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.