Standard
Historical
Last Updated: Jul 16, 2018
Track Document
ASTM G115-10(2013)
Standard Guide for Measuring and Reporting Friction Coefficients
Standard Guide for Measuring and Reporting Friction Coefficients
G0115-10R13
ASTM|G0115-10R13|en-US
Standard Guide for Measuring and Reporting Friction Coefficients
Standard
G115 Standard Guide for Measuring and Reporting Friction Coefficients>
new
BOS Vol. 03.02 Committee G02
$
96.00
In stock
Significance and Use
5.1 In this guide, factors that shall be considered in conducting a valid test for the determination of the coefficient of friction of a tribosystem are covered, and the use of a standard reporting format for friction data is encouraged.
5.2 The factors that are important for a valid test may not be obvious to non-tribologists, and the friction tests referenced will assist in selecting the apparatus and test technique that is most appropriate to simulate a tribosystem of interest.
5.3 The tribology literature is replete with friction data that cannot readily be used by others because specifics are not presented on the tribosystem that was used to develop the data. The overall goal of this guide is to provide a reporting format that will enable computer databases to be readily established. These databases can be searched for material couples and tribosystems of interest. Their use will significantly reduce the need for each laboratory to do its own testing. Sufficient information on test conditions will be available to determine applicability of the friction data to the engineer's specific needs.
Scope
1.1 This guide covers information to assist in the selection of a method for measuring the frictional properties of materials. Requirements for minimum data and a format for presenting these data are suggested. The use of the suggested reporting form will increase the long-term usefulness of the test results within a given laboratory and will facilitate the exchange of test results between laboratories. It is hoped that the use of a uniform reporting format will provide the basis for the preparation of handbooks and computerized databases.
1.2 This guide applies to most solid materials and to most friction measuring techniques and test equipment.
1.3 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.