Standard
Historical
Last Updated: Aug 16, 2017
Track Document
ASTM G99-95a(2000)e1
Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
G0099-95AR00E01
ASTM|G0099-95AR00E01|en-US
Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
Standard
G99 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus>
new
BOS Vol. 03.02 Committee G02
$
86.00
In stock
Scope
1.1 This test method describes a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.