Standard
Historical
Last Updated: Jan 11, 2018
Track Document
ASTM F3066/F3066M-15
Standard Specification for Powerplant Systems Specific Hazard Mitigation
Standard Specification for Powerplant Systems Specific Hazard Mitigation
F3066_F3066M-15
ASTM|F3066_F3066M-15|en-US
Standard Specification for Powerplant Systems Specific Hazard Mitigation
Standard
F3066/F3066M Standard Specification for Powerplant Systems Specific Hazard Mitigation>
new
BOS Vol. 15.09 Committee F44
$
86.00
In stock
Abstract
This specification covers minimum requirements for hazard mitigation in propulsion systems installed on small aeroplanes. The applicant for a design approval must seek the individual guidance to their respective civil aviation authority (CAA) body concerning the use of this specification as part of a certification plan.
The requirements prescribed in this specification cover: engines (turbine engine installations, engine isolation), powerplant ice protection (induction system icing protection, turbine engines, engine rain hail ice and bird ingestion, etc.), designated fire zones (for reciprocating engine, for turbine engines), fire protection (combustion heater, shutoff means), firewalls, fire detection, fire extinguishing, and flammable fluid fire protection.
Scope
1.1 This specification covers minimum requirements for hazard mitigation in propulsion systems installed on small aeroplanes.
1.2 The applicant for a design approval must seek the individual guidance to their respective CAA body concerning the use of this standard as part of a certification plan. For information on which CAA regulatory bodies have accepted this standard (in whole or in part) as a means of compliance to their Small Aircraft Airworthiness regulations (Hereinafter referred to as “the Rules”), refer to ASTM F44 webpage (www.ASTM.org/COMITTEE/F44.htm) which includes CAA website links.
1.3 Units—The values stated are SI units followed by imperial units in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.