Standard
Historical
Last Updated: May 04, 2017
Track Document
ASTM F2055-10
Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
F2055-10
ASTM|F2055-10|en-US
Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method
Standard
F2055 Standard Test Method for Size and Squareness of Resilient Floor Tile by Dial Gage Method>
new
BOS Vol. 15.04 Committee F06
$
86.00
In stock
Significance and Use
Both dimension and squareness of resilient floor tile are important considerations, because installed flooring may exhibit an objectionable appearance when either or both characteristics deviate from established tolerances. This test method provides a means of determining actual dimensions and squareness by using a single apparatus and procedure.
Scope
1.1 This test method covers the determination of both dimensions (length and width) and squareness of resilient floor tile. This test method is intended for use with square tiles ranging from a nominal 9 in. (226 mm) to 40 in. (1016 mm) in dimension.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.