Standard
Historical
Last Updated: Sep 09, 2025
Track Document
ASTM F1926/F1926M-14(2021)
Standard Test Method for Dissolution Testing of Calcium Phosphate Granules, Fabricated Forms, and Coatings
Standard Test Method for Dissolution Testing of Calcium Phosphate Granules, Fabricated Forms, and Coatings
F1926_F1926M-14R21
ASTM|F1926_F1926M-14R21|en-US
Standard Test Method for Dissolution Testing of Calcium Phosphate Granules, Fabricated Forms, and Coatings
Standard
F1926/F1926M Standard Test Method for Dissolution Testing of Calcium Phosphate Granules, Fabricated Forms, and Coatings>
new
BOS Vol. 13.01 Committee F04
$
86.00
In stock
ASTM International
Significance and Use
4.1 Aspects of the biological response to calcium phosphate materials in soft tissue and bone have been reported from laboratory studies and clinical use (1-11).3
4.2 The requirements of this test method apply to calcium phosphate materials such as calcium hydroxyapatite (see Specification F1185), beta-tricalcium phosphate (see Specification F1088), and biphasic mixtures thereof with or without intentional addition of other minor (<10 %) components.
4.3 This test method is limited to the laboratory evaluation of the dissolution rate of a calcium phosphate material. No correlation of the results to in-vivo performance is implied. Therefore, it is recommended that a control material be included in the evaluation. The control material can be a standardized material such as NIST SRM 2910 or a historical control.
Scope
1.1 This test method covers calcium phosphate materials intended for use in surgical implant applications.
1.2 The material(s) shall be representative of that produced for sale. It shall have been produced and processed under standard manufacturing conditions.
1.3 The materials may be in the form of powders, granules, spall material, fabricated forms, or coatings; and may be porous, nonporous, textured, and other implantable topographical substrate form representative of the end-use product.
1.4 The calcium phosphate material may constitute the only material in a substrate or it may be one of multiple materials so long as all other materials present do not dissolve under the test conditions described in this test method.
1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.