There is no PDF download available at this time. Please contact customer service.
Standard
Withdrawn, No replacement
Last Updated: Jan 15, 2026
Track Document
ASTM F1833-97(2017)
Standard Test Method for Comparison of Rearfoot Motion Control Properties of Running Shoes (Withdrawn 2026)
Standard Test Method for Comparison of Rearfoot Motion Control Properties of Running Shoes (Withdrawn 2026)
F1833-97R17
ASTM|F1833-97R17|en-US
Standard Test Method for Comparison of Rearfoot Motion Control Properties of Running Shoes (Withdrawn 2026)
Standard
F1833 Standard Test Method for Comparison of Rearfoot Motion Control Properties of Running Shoes (Withdrawn 2026)>
new
BOS Vol. 15.07 Committee F08
$
0.00
Out of stock
ASTM International
Significance and Use
5.1 This test method allows the rearfoot control properties of running shoes or corrective orthoses within shoes to be compared provided they are tested concurrently and under identical conditions.
5.2 Tests of this type are commonly used in the development and performance testing of running shoes and other in-shoe devices. Careful adherence to the requirements and recommendations of this test shall provide results which can be compared between different laboratories.
Note 1: The variance in rearfoot motion due to differences between shoes is generally smaller than the variance between subjects. Direct comparisons between shoes tested in different experiments is therefore not possible.
Scope
1.1 This test method covers the measurement of certain angular motions of the lower extremity during running, specifically, the frontal plane projection of the pronation and supination of the lower leg relative to the foot (“rearfoot motion”) and methods by which the effects of different running shoes on rearfoot motion may be compared.
1.2 As used in this test method, footwear may refer to running shoes, corrective shoe inserts (orthoses) or specific combinations of both. The effects of orthoses may vary from shoe to shoe. Therefore, comparisons involving orthoses shall be qualified by the specific style of shoes in which they are tested.
1.3 This test method is limited to the measurement of the two dimensional, frontal plane projection of the relative angular motion between the lower leg and the foot (“rearfoot motion”). It is not a direct measure of pronation or supination, which are three dimensional motions.
1.4 This test method is limited to running motions in which the heel makes first contact with the ground during each step.
1.5 This test method is applicable to measurements of rearfoot motion made while subjects run on a treadmill or while they run overground under controlled conditions.
1.6 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.