Standard
Historical
Last Updated: Aug 16, 2017
Track Document
ASTM F1309-98(2003)
Standard Practice for Installation Procedures for Fitting Chocks to Marine Machinery Foundations
Standard Practice for Installation Procedures for Fitting Chocks to Marine Machinery Foundations
F1309-98R03
ASTM|F1309-98R03|en-US
Standard Practice for Installation Procedures for Fitting Chocks to Marine Machinery Foundations
Standard
F1309 Standard Practice for Installation Procedures for Fitting Chocks to Marine Machinery Foundations>
new
BOS Vol. 01.07 Committee F25
$
86.00
In stock
Significance and Use
This practice provides the three principal methods of fitting chocks to marine machinery foundations to ensure that the machinery is free of vibration and perfectly aligned after installation.
3.1.1 The three principal methods of installing chocks described herein are as follows:
3.1.1.1 Type A—Epoxy-based resin, nonshrinking Chockfast Orange PR 610 TCF by Philadelphia Resin Corp., or equal, and
3.1.1.2 Type B—Two-piece wedge chocks.
3.1.1.3 Type C—Solid, one-piece fitted chocks.
Scope
1.1 This practice covers the acceptable methods of fitting chocks to marine machinery foundations.
1.2 The values stated in SI units shall be regarded as standard. The values in parentheses are for information only.
1.3 This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.