Standard
Historical
Last Updated: Jun 14, 2021
Track Document
ASTM F1303-04(2014)
Standard Specification for Sheet Vinyl Floor Covering with Backing
Standard Specification for Sheet Vinyl Floor Covering with Backing
F1303-04R14
ASTM|F1303-04R14|en-US
Standard Specification for Sheet Vinyl Floor Covering with Backing
Standard
F1303 Standard Specification for Sheet Vinyl Floor Covering with Backing>
new
BOS Vol. 15.04 Committee F06
$
77.00
In stock
Abstract
This specification covers resilient floor covering having a vinyl plastic wear layer with backing intended for use in commercial, light commercial, and residential building applications. Material covered by this specification consists of Types I and II floor covering, which may further be classified according to grade (Grades 1, 2, and 3) and backing classes (Class A, B, and C). the floor covering shall consist of a vinyl plastic wear layer (transparent, translucent, or opaque, with the surface smooth, embossed, or textured with or without valley printing), intermediate layers made of foam and reinforcing materials, and backing (which may be fibrous, nonfoamed plastic, or foamed plastic). Tests for wear layer binder content, wear layer thickness, overall thickness, residual indentation, flexibility, and resistance to chemicals, heat, light, and static load shall be performed and shall conform to the requirements specified.
Scope
1.1 This specification covers floor covering having a vinyl plastic wear layer with backing. Products may also contain non-PVC specialty performance top layer(s) or intermediate layer(s), or both.
1.2 Two types of floor covering based on binder content are covered. The floor covering is intended for use in commercial, light commercial, and residential buildings based on serviceability characteristics. General information and performance characteristics that determine serviceability and recommended use are included in this specification.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.