Standard
Active
Last Updated: May 31, 2023
Track Document
ASTM F1093-99(2023)
Standard Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom
Standard Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom
F1093-99R23
ASTM|F1093-99R23|en-US
Standard Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom
Standard
F1093 Standard Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom>
new
BOS Vol. 11.08 Committee F20
$
64.00
In stock
ASTM International
Significance and Use
5.1 Boom sections are frequently combined into assemblages hundreds of meters in length prior to towing through the water to a spill site. The friction of moving long boom assemblages through the water can impose high tensile stresses on boom segments near the tow vessel.
5.2 Tensile forces are also set up in a boom when it is being towed in a sweeping mode. The magnitude of this tensile force can be related to the immersed depth of the boom, the length of boom involved, the width of the bight formed by the two towing vessels, and the speed of movement.
Note 1: When the towing speed exceeds about 1 knot (0.5 m/s), substantial oil will be lost under the boom.
5.3 Knowledge of maximum and allowable working tensile stresses will help in the selection of boom for a given application and will permit specification of safe towing and anchoring conditions for any given boom.
Scope
1.1 These test methods cover static laboratory tests of the strength of oil spill response boom under tensile loading.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.