Standard
Historical
Last Updated: Feb 06, 2012
Track Document
ASTM F880-02(2008)
Standard Specification for Stainless Steel Socket-Set Screws
Standard Specification for Stainless Steel Socket-Set Screws
F0880-02R08
ASTM|F0880-02R08|en-US
Standard Specification for Stainless Steel Socket-Set Screws
Standard
F880 Standard Specification for Stainless Steel Socket-Set Screws>
new
BOS Vol. 01.09 Committee F16
$
86.00
In stock
Abstract
This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS). The austenitic stainless steel socket set screw shall be designated as condition AF (solution annealed) or Condition CW (cold worked). The screw may be forged, formed, extruded, machined, or ground to meet the dimensional characteristics and performance requirements. The analysis of the screw material shall conform to the chemical composition specified. Chemical analysis; socket strength torque test; and corrosion resistance shall be performed to conform with the requirements specified.
Scope
1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 0.500 in., in two conditions, AF and CW.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1—A complete metric companion to Specification F 880 has been developed—F 880M; therefore, no metric equivalents are shown in this specification.
1.3 The following hazards caveat pertains only to Test Method Section, Section 12 of this specification. This standard does not purport to address (all of) the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.