Standard
Historical
Last Updated: May 13, 2024
Track Document
ASTM F639-09(2015)
Standard Specification for Polyethylene Plastics for Medical Applications
Standard Specification for Polyethylene Plastics for Medical Applications
F0639-09R15
ASTM|F0639-09R15|en-US
Standard Specification for Polyethylene Plastics for Medical Applications
Standard
F639 Standard Specification for Polyethylene Plastics for Medical Applications>
new
BOS Vol. 13.01 Committee F04
$
77.00
In stock
ASTM International
Significance and Use
X1.2 Significance
X1.2.1 Concentrations of trace metals are measured as extracts in simulated body fluids. The metal’s concentration in extracts is based on the surface area of the plastic extracted from which the total amount of metal deliverable to the patient may be estimated.
Abstract
This specification covers the properties for polyethylene plastics for use in medical device applications involving human tissue contact devices, short term indwellings, and fluid transfer devices. Biocompatibility tests must be conducted on the final products as the biocompatibility of these materials as a class has not been established. Plyethylene plastics should consist of basic polymers with ethylene as essentially the sole monomer. The compound may contain optional adjuvant substances required in polymer production or fabrication. The final compound should yield a consistent absorption spectrum characteristic of the established formulation. The polyethylene plastics should be tested using the specified physical test procedures for density, melt flow, tensile properties, compressive properties, stiffness, flexural fatigue, and other flexural properties.
Scope
1.1 This specification covers polyethylene plastics (as defined in Terminology D883) intended for use in medical device applications involving human tissue contact devices, short-term indwellings of 30 days or less, and fluid transfer devices. The biocompatibility of these materials as a class has not been established. Biocompatibility tests must be conducted on the final product.
1.2 This specification is not applicable to ultra-high molecular weight polyethylenes (UHMWPE) plastics, such as those used in joint implants, and so forth.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.