Standard
Active
Last Updated: Jun 20, 2019
Track Document
ASTM F607-03(2019)
Standard Test Method for Adhesion of Gasket Materials to Metal Surfaces
Standard Test Method for Adhesion of Gasket Materials to Metal Surfaces
F0607-03R19
ASTM|F0607-03R19|en-US
Standard Test Method for Adhesion of Gasket Materials to Metal Surfaces
Standard
F607 Standard Test Method for Adhesion of Gasket Materials to Metal Surfaces>
new
BOS Vol. 09.02 Committee F03
$
64.00
In stock
Significance and Use
4.1 This test method provides terms such as megapascals or pounds-force per square inch of gasket surface for expressing the extent of adhesion applicable to all materials within the scope of Classification System F104. Under certain conditions, adhesion develops when gasket materials are confined in a compressed state between metal flanges. Adhesion is important as an index of ease of removal of a gasket material. Since other variables may enter into the performance in an application, the results obtained should be correlated with field results. A typical set of conditions is described in this test method. This test method may be used as an acceptance test when agreed upon between the user and the producer.
Scope
1.1 This test method provides a means of determining the degree to which gasket materials under compressive load adhere to metal surfaces. The test conditions described are indicative of those frequently encountered in gasket applications. Test conditions may also be modified in accordance with the needs of specific applications as agreed upon between the user and the producer. The maximum temperature recommended for this test method is 205°C (400°F).
1.2 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.