Standard
Active
Last Updated: May 07, 2024
Track Document
ASTM F319-19(2024)
Standard Practice for Polarized Light Detection of Flaws in Aerospace Transparency Heating Elements
Standard Practice for Polarized Light Detection of Flaws in Aerospace Transparency Heating Elements
F0319-19R24
ASTM|F0319-19R24|en-US
Standard Practice for Polarized Light Detection of Flaws in Aerospace Transparency Heating Elements
Standard
F319 Standard Practice for Polarized Light Detection of Flaws in Aerospace Transparency Heating Elements>
new
BOS Vol. 15.03 Committee F07
$
64.00
In stock
ASTM International
Significance and Use
4.1 This practice is useful as a screening basis for acceptance or rejection of transparencies during manufacturing so that units with identifiable flaws will not be carried to final inspection for rejection at that time.
4.2 This practice may also be employed as a go-no go technique for acceptance or rejection of the finished product.
4.3 This practice is simple, inexpensive, and effective. Flaws identified by this practice, as with other optical methods, are limited to those that produce temperature gradients when electrically powered. Any other type of flaw, such as minor scratches parallel to the direction of electrical flow, are not detectable.
Scope
1.1 This practice covers a standard procedure for detecting flaws in the conductive coating (heater element) by the observation of polarized light patterns.
1.2 This practice applies to coatings on surfaces of monolithic transparencies as well as to coatings imbedded in laminated structures.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 6.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.