Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM E2209-02(2006)e1
Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry
Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry
E2209-02R06E01
ASTM|E2209-02R06E01|en-US
Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry
Standard
E2209 Standard Test Method for Analysis of High Manganese Steel Using Atomic Emission Spectrometry>
new
BOS Vol. 03.05 Committee E01
$
86.00
In stock
Significance and Use
The chemical composition of high manganese steel alloys must be determined accurately to ensure the desired metallurgical properties. This procedure is suitable for manufacturing control and inspection testing.
Scope
1.1 This method provides for the analysis of high manganese steel by atomic emission spectrometry using the point-to-plane technique for the following elements in the concentration ranges shown:
| Elements | Concentration Range, % |
| Aluminum (Al) | 0.02 to 0.15 |
| Carbon (C) | 0.3 to 1.4 |
| Chromium (Cr) | 0.25 to 2.00 |
| Manganese (Mn) | 8.0 to 16.2 |
| Molybdenum (Mo) | 0.03 to 2.0 |
| Nickel (Ni) | 0.05 to 4.0 |
| Phosphorus (P) | 0.025 to 0.06 |
| Silicon (Si) | 0.25 to 1.5 |
Note 1—The ranges represent the actual levels at which this method was tested. These concentration ranges can be extended to higher concentrations by the use of suitable reference materials. Sulfur is not included because differences in results between laboratories exceeded acceptable limits at all analyte levels.
1.2 This test method may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.