Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM E1911-09
Standard Test Method for Measuring Paved Surface Frictional Properties Using the Dynamic Friction Tester
Standard Test Method for Measuring Paved Surface Frictional Properties Using the Dynamic Friction Tester
E1911-09
ASTM|E1911-09|en-US
Standard Test Method for Measuring Paved Surface Frictional Properties Using the Dynamic Friction Tester
Standard
E1911 Standard Test Method for Measuring Paved Surface Frictional Properties Using the Dynamic Friction Tester>
new
BOS Vol. 04.03 Committee E17
$
86.00
In stock
Significance and Use
This test method provides a measure of surface friction as a function of sliding speed, either in the field or in a laboratory.
This test method may be used to determine the relative effects of various polishing techniques on materials or material combinations.
The values measured in accordance with this method do not necessarily agree or directly correlate with those obtained utilizing other methods of determining friction properties or skid resistance.
Scope
1.1 This test method covers the procedure for measuring paved surface frictional properties as a function of speed using the Dynamic Friction Tester (DF-Tester).
1.2 The DF Tester consists of a horizontal spinning disk fitted with three spring loaded rubber sliders which contact the paved surface as the disk rotational speed decreases due to the friction generated between the sliders and the paved surface. A water supply unit delivers water to the paved surface being tested. The torque generated by the slider forces measured during the spin down is then used to calculate the friction as a function of speed.
1.3 The DF Tester can be used for laboratory investigations and in the field on actual paved surfaces.
1.4 The values stated in SI (metric) units are to be regarded as standard. The inch-pound equivalents are rationalized, rather than exact mathematical conversions.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.