Standard
Historical
Last Updated: Nov 25, 2019
Track Document
ASTM E1129/E1129M-15
Standard Specification for Thermocouple Connectors
Standard Specification for Thermocouple Connectors
E1129_E1129M-15
ASTM|E1129_E1129M-15|en-US
Standard Specification for Thermocouple Connectors
Standard
E1129/E1129M Standard Specification for Thermocouple Connectors>
new
BOS Vol. 14.03 Committee E20
$
86.00
In stock
Significance and Use
4.1 The widespread use of thermocouple connectors requires standardization of mating dimensions and performance characteristics.
4.2 This specification describes standardized thermocouple connector dimensions and capabilities and includes test procedures suitable for evaluating the performance of a particular specimen or design. The tests described are not intended for routine inspection or rapid testing of large groups of connectors or for quality control purposes.
Abstract
This specification covers separable single-circuit thermocouple connectors with two round pins. The widespread use of thermocouple connectors requires standardization of mating dimensions and performance characteristics. Connectors shall be constructed as either plugs or jacks, and these two forms shall be designed to connect with each other. Contact resistance test, thermal gradient test, and insulation resistance test shall be performed to meet the requirements prescribed.
Scope
1.1 This specification covers separable single-circuit thermocouple connectors with two round pins. Connectors covered by this specification must be rated for continuous use to at least 300°F (150°C), but they may optionally be rated to a higher temperature.
1.2 This specification does not cover multiple-circuit connectors, multi-pin connectors, miniature connectors, or connectors intended primarily for panel mounting. High temperature connectors (for example, those designed for continuous use at temperatures above approximately 500°F (260°C)) are not intended to be covered by this specification.
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard.
1.4 The following precautionary statement pertains only to the test methods portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.