Standard
Historical
Last Updated: Jul 06, 2022
Track Document
ASTM E1003-13(2018)
Standard Practice for Hydrostatic Leak Testing
Standard Practice for Hydrostatic Leak Testing
E1003-13R18
ASTM|E1003-13R18|en-US
Standard Practice for Hydrostatic Leak Testing
Standard
E1003 Standard Practice for Hydrostatic Leak Testing>
new
BOS Vol. 03.03 Committee E07
$
77.00
In stock
Significance and Use
6.1 This practice is useful for quality control testing and field inspection of piping systems, pipelines, valves, and containers that are expected to retain liquids. It is not sensitive enough for leak testing when toxic or explosive gas is expected to be retained under pressure.
Scope
1.1 This practice covers the testing of components for leaks by pressurizing them inside with a liquid.
1.2 This practice can be used on piping, valves, and containers with welded or fitted sections which can be sealed at their ends and which are designed for internal pressure.
1.3 Basic procedures are described based on the type of inspection used. These procedures should be limited to finding leakage indications of 4.5 × 10−9 mol/s (1 × 10−4 Std cm3/s)2 or larger.
1.4 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.