Standard
Historical
Last Updated: Jan 14, 2013
Track Document
ASTM E810-03(2008)
Standard Test Method for Coefficient of Retroreflection of Retroreflective Sheeting Utilizing the Coplanar Geometry
Standard Test Method for Coefficient of Retroreflection of Retroreflective Sheeting Utilizing the Coplanar Geometry
E0810-03R08
ASTM|E0810-03R08|en-US
Standard Test Method for Coefficient of Retroreflection of Retroreflective Sheeting Utilizing the Coplanar Geometry
Standard
E810 Standard Test Method for Coefficient of Retroreflection of Retroreflective Sheeting Utilizing the Coplanar Geometry>
new
BOS Vol. 06.01 Committee E12
$
86.00
In stock
Significance and Use
Measurements made by this test method are related to visual observations of retroreflective sheeting as seen by the human eye when illuminated by tungsten-filament light sources such as a motor vehicle headlamp.
The values determined relate to the visual effects for a given geometric configuration as specified by the user of the test method. This test method has been found useful for tests at observation angles between 0.1 and 2.0° (observation angles between 0.1° and 0.2° may be achieved by careful design of source and receiver aperture configuration), and at entrance angles up to 60°. It has been used to determine coefficient of retroreflection values as low as 0.1 cd·lx−1· m−2, but for values less than 1 cd·lx−1· m−2 special attention must be given to the responsivity of the receiver and to the elimination of very small amounts of stray light.
Scope
1.1 This test method describes an instrument measurement of the retroreflective performance of retroreflective sheeting.
1.2 The user of this test method must specify the entrance and observation angles to be used, and may specify the rotation angles.
1.3 This test method is intended as a laboratory test and requires a facility that can be darkened sufficiently so that stray light does not affect the test results. The testing apparatus must be able to achieve the coplanar geometry.
1.4 Portable and bench retroreflection measuring equipment may be used to determine RA values provided the geometry and appropriate substitution standard reference panels, measured in accordance with this test method, are utilized. In this case the methods of Procedure B in Practice E 809
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.