Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM E775-87(2004)
Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel
Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel
E0775-87R04
ASTM|E0775-87R04|en-US
Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel
Standard
E775 Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel>
new
BOS Vol. 11.04 Committee D34
$
77.00
In stock
Significance and Use
The standards are available to producers and users of RDF for determining the total sulfur content of the fuel.
Scope
1.1 These test methods cover two alternative procedures for the determination of total sulfur in prepared analysis samples of solid forms of refuse-derived fuel (RDF). Sulfur is included in the ultimate analysis of RDF.
1.2 The test methods appear in the following order:
| Test | Sections |
| Eschka Method | |
| Bomb Washing Method |
1.3 These test methods may be applicable to any waste material from which a laboratory analysis sample can be prepared.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section 6.