Standard
Historical
Last Updated: Oct 21, 2022
Track Document
ASTM E695-03(2015)e1
Standard Test Method of Measuring Relative Resistance of Wall, Floor, and Roof Construction to Impact Loading
Standard Test Method of Measuring Relative Resistance of Wall, Floor, and Roof Construction to Impact Loading
E0695-03R15E01
ASTM|E0695-03R15E01|en-US
Standard Test Method of Measuring Relative Resistance of Wall, Floor, and Roof Construction to Impact Loading
Standard
E695 Standard Test Method of Measuring Relative Resistance of Wall, Floor, and Roof Construction to Impact Loading>
new
BOS Vol. 04.11 Committee E06
$
86.00
In stock
Significance and Use
4.1 The procedures outlined will provide data that can be used to evaluate the relative performance of wall, floor, and roof constructions under conditions representative of those sustained in actual service when subjected to impact by a heavy blunt object. See Test Method E661 for evaluation of floor and roof sheathing and Practice E73 for evaluation of roof trusses.
4.2 The method is intended to be applied to relatively light construction, including, but not limited to, wood floor and roof systems, partitions framed with wood or steel studs, steel floor or roof decking systems, steel siding and wall panels, or thin concrete and masonry walls or slabs and similar assemblies.
Scope
1.1 This test method covers the measurement of the relative resistance of wall, floor, and roof construction to impact loading. The test is not applicable to doors.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.