Standard
Active
Last Updated: May 04, 2020
Track Document
ASTM E576-14(2020)
Standard Test Method for Frost/Dew Point of Sealed Insulating Glass Units in the Vertical Position
Standard Test Method for Frost/Dew Point of Sealed Insulating Glass Units in the Vertical Position
E0576-14R20
ASTM|E0576-14R20|en-US
Standard Test Method for Frost/Dew Point of Sealed Insulating Glass Units in the Vertical Position
Standard
E576 Standard Test Method for Frost/Dew Point of Sealed Insulating Glass Units in the Vertical Position>
new
BOS Vol. 04.11 Committee E06
$
72.00
In stock
Significance and Use
5.1 This test method is suitable for use under actual or simulated in-service conditions; that is, one side of the unit is exposed to room temperature, while the other side is exposed to natural or simulated weather conditions. Where the glazing conditions and the 24 h history are different or changed from previous conditions, the frost/dew point may not be comparable to a previous measurement.
5.2 This test method is applicable for the uncoated or unfilmed clear (transparent) glass lite of sealed insulating glass units. If this apparatus is used with coated or filmed glass lite, the coating or film on the surface of glass lite may be damaged.
5.3 This test method may require minor modifications to keep the measuring surface of the frost/dew-point apparatus in contact with the glass if the insulating glass unit is not in the true vertical position.
Scope
1.1 This test method describes a field or laboratory procedure for determining the frost/dew point within the air space(s) of sealed insulating glass units and establishes the criteria for determining whether that point is below or above a given or specified temperature.
1.2 This test method also describes the apparatus to be used for these determinations.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 9.1.3 and 9.3.8.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.