Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM E517-00(2006)e1
Standard Test Method for Plastic Strain Ratio r for Sheet Metal
Standard Test Method for Plastic Strain Ratio r for Sheet Metal
E0517-00R06E01
ASTM|E0517-00R06E01|en-US
Standard Test Method for Plastic Strain Ratio r for Sheet Metal
Standard
E517 Standard Test Method for Plastic Strain Ratio r for Sheet Metal>
new
BOS Vol. 03.01 Committee E28
$
86.00
In stock
Scope
1.1 This test method covers special tension testing for the measurement of the plastic strain ratio, r, of sheet metal intended for deep-drawing applications.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.