Standard
Active
Last Updated: Aug 27, 2021
Track Document
ASTM E190-21
Standard Test Method for Guided Bend Test for Ductility of Welds
Standard Test Method for Guided Bend Test for Ductility of Welds
E0190-21
ASTM|E0190-21|en-US
Standard Test Method for Guided Bend Test for Ductility of Welds
Standard
E190 Standard Test Method for Guided Bend Test for Ductility of Welds>
new
BOS Vol. 03.01 Committee E28
$
77.00
In stock
ASTM International
Significance and Use
5.1 The guided bend test as described in this test method is used to evaluate the quality of welds as a function of ductility as evidenced by their ability to resist cracking during bending.
Scope
1.1 This test method covers a guided bend test for the determination of soundness and ductility of welds in ferrous and nonferrous products. Flaws, not shown by X rays, can appear in the surface of a specimen when it is subjected to progressive localized overstressing.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.