Standard
Historical
Last Updated: May 09, 2023
Track Document
ASTM D8138-18
Standard Specification for Preformed Silicone Joint Sealing System for Bridges
Standard Specification for Preformed Silicone Joint Sealing System for Bridges
D8138-18
ASTM|D8138-18|en-US
Standard Specification for Preformed Silicone Joint Sealing System for Bridges
Standard
D8138 Standard Specification for Preformed Silicone Joint Sealing System for Bridges>
new
BOS Vol. 04.03 Committee D04
$
77.00
In stock
ASTM International
Abstract
This specification covers the material, manufacturing, and physical requirements for preformed silicone joint seals used in bridges. The seal consists of a silicone rubber gland preformed to a continuous length and is designed to prevent any tension from occurring in the seal or bonding point during normal movement. The seal is installed by bonding it to the joint header with a silicone-based adhesive, sealing the joint to prevent liquid intrusion. Physical requirements for the preformed silicone joint seal gland cover resistance to accelerated weathering, tensile strength, elongation at break, hardness, tear strength, compression set, and heat-aged properties, whereas physical requirements for the silicone-based adhesive cover tensile strength, elongation at break, sag/flow, tack-free time, resistance to UV, and cure through to 1/4-in. thickness.
This specification also includes requirements for working parameters, sampling, specimen preparation, test methods, and certification and acceptance.
Scope
1.1 This specification covers the material requirements for preformed silicone joint seals for bridges. The seal consists of a silicone rubber gland preformed to a continuous length. Its design shall prevent any tension from occurring in the seal or bonding point during normal movement. The seal is installed by bonding it to the joint header with a silicone-based adhesive and is designed to seal the joint, preventing liquid intrusion.
1.2 The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.