Standard
Historical
Last Updated: Jul 03, 2017
Track Document
ASTM D7951-14
Standard Specification for Disproportionation (TDP) Toluene
Standard Specification for Disproportionation (TDP) Toluene
D7951-14
ASTM|D7951-14|en-US
Standard Specification for Disproportionation (TDP) Toluene
Standard
D7951 Standard Specification for Disproportionation (TDP) Toluene>
new
BOS Vol. 06.04 Committee D16
$
77.00
In stock
Abstract
This specification establishes requirements for disproportionation (TDP) toluene. For purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit. This specification covers properties and sampling of the material.
Scope
1.1 This specification covers Disproportionation (TDP) toluene.
1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 Consult current OSHA regulations, supplier’s Safety Data Sheets, and local regulations for all materials used in this specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.