Standard
Active
Last Updated: May 04, 2022
Track Document
ASTM D7795-15(2022)e1
Standard Test Method for Acidity in Ethanol and Ethanol Blends by Titration
Standard Test Method for Acidity in Ethanol and Ethanol Blends by Titration
D7795-15R22E01
ASTM|D7795-15R22E01|en-US
Standard Test Method for Acidity in Ethanol and Ethanol Blends by Titration
Standard
D7795 Standard Test Method for Acidity in Ethanol and Ethanol Blends by Titration>
new
BOS Vol. 05.04 Committee D02
$
72.00
In stock
Significance and Use
5.1 This test method measures acidity in ethanol or ethanol blends quantitatively. Denatured fuel ethanol may contain additives such as corrosion inhibitors and detergents as well as contaminants from manufacturing that can affect the acidity of finished ethanol fuel. Very dilute aqueous solutions of low molecular mass organic acids, such as acetic acid, are highly corrosive to many metals. It is important to keep such acids at a very low level.
5.2 Acceptable levels of acidity in ethanol or ethanol blends can vary with different specifications but in general it is below 200 mg/kg (ppm). Knowledge of the acidity can be required to establish whether the product quality meets specification.
Scope
1.1 This test method covers the determination of acidity as acetic acid (see Specification D4806) in commonly available grades of denatured ethanol, and ethanol blends with gasoline ranging from E95 to E30. This test method is used for determining low levels of acidity, below 200 mg/kg (ppm mass), with the exclusion of carbon dioxide.
1.1.1 Procedure A—Developed specifically for measurement of acidity by potentiometric titration. This is the referee method.
1.1.2 Procedure B—Developed specifically for measurement of acidity by color end point titration.
1.2 The ethanol and ethanol blends may be analyzed directly by this test method without any sample preparation.
1.3 Review the current and appropriate Material Safety Data Sheets (MSDS) for detailed information concerning toxicity, first aid procedures, and safety precautions and proper personal protective equipments.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.