Standard
Active
Last Updated: Feb 16, 2018
Track Document
ASTM D7275-07(2018)
Standard Test Method for Tensile Properties of Bituminous Geomembranes (BGMs)
Standard Test Method for Tensile Properties of Bituminous Geomembranes (BGMs)
D7275-07R18
ASTM|D7275-07R18|en-US
Standard Test Method for Tensile Properties of Bituminous Geomembranes (BGMs)
Standard
D7275 Standard Test Method for Tensile Properties of Bituminous Geomembranes (BGMs)>
new
BOS Vol. 04.13 Committee D35
$
64.00
In stock
Significance and Use
4.1 This method is used to evaluate the tensile properties of BGMs. It can be used for manufacturing quality control or acceptance testing.
4.2 This test method uses a dumbbell specimen. The shape and dimensions of the specimen are defined in this standard. No other shape or dimensions are allowed. Other mechanical properties of BGMs may be measured using different test methods. Refer to Guide D6455.
4.3 The reported properties are the maximum strength and elongation at maximum strength.
Scope
1.1 This test method is used to measure the tensile properties of bituminous geomembranes (BGMs) using a dumbbell-shaped specimen.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.