Cart
Cart
ASTM Logo
Standard Historical Last Updated: Jul 11, 2017 Track Document
ASTM D7238-06(2012)

Standard Test Method for Effect of Exposure of Unreinforced Polyolefin Geomembrane Using Fluorescent UV Condensation Apparatus

Standard Test Method for Effect of Exposure of Unreinforced Polyolefin Geomembrane Using Fluorescent UV Condensation Apparatus D7238-06R12 ASTM|D7238-06R12|en-US Standard Test Method for Effect of Exposure of Unreinforced Polyolefin Geomembrane Using Fluorescent UV Condensation Apparatus Standard new BOS Vol. 04.13 Committee D35
$ 77.00 In stock

Significance and Use

5.1 The use of this apparatus is intended to induce property changes associated with the end use conditions, including the effects of the UV portion of sunlight, moisture, and heat. Exposures are not intended to simulate the deterioration caused by localized weather phenomena, such as atmospheric pollution, biological attack, and saltwater exposure.

Note 3—Refer to Practice G151 for cautionary guidance applicable to laboratory weathering devices.

5.2 Variation in results may be expected when operating conditions are varied within the accepted limits of this method.

5.3 Test data for one thickness of a geomembrane can not be used as data for other thickness geomembranes made with the same formula (polymer, pigment and stabilizers) since the degradation is thickness related.

Note 4—It is recommended that a similar material of known performance (a control) be exposed simultaneously with the test material to provide a standard for comparative purposes. When control material is used in the test program, it is recommended only one coupon be used for each UV exposure period to allow for OIT testing.

Scope

1.1 This standard covers the specific procedures and test conditions that are applicable for exposure of unreinforced polyolefin geomembranes to fluorescent UV radiation and condensation.

Note 1—Polyolefin geomembranes include high density polyethylene (HDPE), linear low density polyethylene (LLDPE), flexible polyproplyene (fPP), etc.

1.2 Test specimens are exposed to fluorescent UVA 340 lamps under controlled environmental conditions. UVA 340 lamps are standard for this method.

Note 2—Other types of fluorescent UV lamps, such as UVB-313, can also be used based upon discussion between involved parties. However, if the test is ran with another type of fluorescent UV lamps, such as UVB-313, this should be considered as a deviation from the standard and clearly stated in the test report. UVB-313 and UVA-340 fluorescent lamps generate different amount of radiant power in different wavelength ranges; thus, the photochemical effects caused by these different lamps may vary.

1.3 This method covers the conditions under which the exposure is to be performed and the test methods for evaluating the effects of fluorescent UV, heat and moisture in the form of condensation on geomembranes. General guidance is given in Practices G151 and G154.

1.4 The values listed in SI units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

D7238-20 Active D7238-06R17 D7238-06
Price:
Contact Sales
Shipping & Handling
Related

ASTM License Agreement

Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.13
Developed by Subcommittee: D35.02
Pages: 4
DOI: 10.1520/D7238-06R12
ICS Code: 59.080.70