Standard
Historical
Last Updated: May 05, 2022
Track Document
ASTM D6933-18
Standard Test Method for Oversized Particles in Emulsified Asphalts (Sieve Test)
Standard Test Method for Oversized Particles in Emulsified Asphalts (Sieve Test)
D6933-18
ASTM|D6933-18|en-US
Standard Test Method for Oversized Particles in Emulsified Asphalts (Sieve Test)
Standard
D6933 Standard Test Method for Oversized Particles in Emulsified Asphalts (Sieve Test)>
new
BOS Vol. 04.03 Committee D04
$
77.00
In stock
Significance and Use
3.1 The retention of an excessive amount of particles on the sieve indicates that problems may occur in handling and application of the material. Particles of asphalt retained on the sieve are often caused by agglomeration of the dispersed phase. Storage, pumping, handling, and temperature can all contribute to the formation of particles. Contamination from the tank, transport, or hose are other factors affecting particle formation.
Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.
Scope
1.1 This test method covers the degree to which an emulsified asphalt may contain particles of asphalt or other discreet solids retained on a 850-μm mesh sieve.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.