Standard
Active
Last Updated: Dec 15, 2020
Track Document
ASTM D6900-10(2020)
Standard Test Method for Wet Adhesion of Latex Paints to a Gloss Alkyd Enamel Substrate
Standard Test Method for Wet Adhesion of Latex Paints to a Gloss Alkyd Enamel Substrate
D6900-10R20
ASTM|D6900-10R20|en-US
Standard Test Method for Wet Adhesion of Latex Paints to a Gloss Alkyd Enamel Substrate
Standard
D6900 Standard Test Method for Wet Adhesion of Latex Paints to a Gloss Alkyd Enamel Substrate>
new
BOS Vol. 06.02 Committee D01
$
64.00
In stock
Significance and Use
5.1 After application to either interior or exterior surfaces, latex paints may be subjected to conditions of high humidity, condensation, or precipitation. This may sometimes lead to a loss of adhesion to the substrate over which they have been applied. This method is a quantitative measure of the adhesion of latex paints to glossy substrates under such conditions.
Scope
1.1 This test method covers a procedure for measuring by scrubbing the adhesion of latex paints to glossy alkyd enamel substrates after exposure to wet conditions.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.