Standard
Historical
Last Updated: Aug 01, 2017
Track Document
ASTM D6878/D6878M-13
Standard Specification for Thermoplastic Polyolefin Based Sheet Roofing
Standard Specification for Thermoplastic Polyolefin Based Sheet Roofing
D6878_D6878M-13
ASTM|D6878_D6878M-13|en-US
Standard Specification for Thermoplastic Polyolefin Based Sheet Roofing
Standard
D6878/D6878M Standard Specification for Thermoplastic Polyolefin Based Sheet Roofing>
new
BOS Vol. 04.04 Committee D08
$
77.00
In stock
Abstract
This specification covers flexible sheet made from thermoplastic polyolefin (TPO) as the principal polymer, intended for use in single-ply roofing membranes exposed to the weather. The sheet shall contain reinforcing fabrics or scrims. The sheet shall be formulated from ethylene and higher alpha-olefin polymers, copolymers, and mixtures thereof, in amounts greater than 50 %, by weight of the total polymer content suitably compounded to satisfy the physical requirements specified. The sheet shall be capable of being heat welded, fused, or adhesively bonded to itself for making watertight field splices and repairs and shall be reinforced with fabric or scrim. Different tests shall be performed in order to determine the following physical properties of thermoplastic polyolefin sheets: dimensions, sheet overall thickness, coating thickness over scrim, breaking strength, elongation at break, tearing strength, brittleness point, ozone resistance, heat aging, linear dimensional change, water absorption, factory seam strength, and weather resistance.
Scope
1.1 This specification covers flexible sheet made from thermoplastic polyolefin (TPO) as the principal polymer, intended for use in single-ply roofing membranes exposed to the weather. The sheet shall contain reinforcing fabrics or scrims.
1.2 The tests and property limits used to characterize the sheet are values intended to ensure minimum quality for the intended purpose. In-place roof system design criteria, such as fire resistance, field seaming strength, material compatibility, and uplift resistance, among others, are factors which should be considered but are beyond the scope of this specification.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.