Standard
Historical
Last Updated: Feb 10, 2014
Track Document
ASTM D6814-02(2008)
Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density
Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density
D6814-02R08
ASTM|D6814-02R08|en-US
Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density
Standard
D6814 Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density>
new
BOS Vol. 09.01 Committee D11
$
77.00
In stock
Significance and Use
It is important for rubber compounders to know the extent of devulcanization a rubber might have undergone during recycling. It allows the compounder to determine if more curing agents are needed during mixing of devulcanized rubber when used either as partial replacement or stand alone.
Scope
1.1 This test method covers the procedure for determining percent devulcanization from crosslink density measurements of devulcanized rubber and control crumb rubber in the laboratory. Percent devulcanization is a quantitative determination.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.