Standard
Historical
Last Updated: May 11, 2021
Track Document
ASTM D6690-15
Standard Specification for Joint and Crack Sealants, Hot Applied, for Concrete and Asphalt Pavements
Standard Specification for Joint and Crack Sealants, Hot Applied, for Concrete and Asphalt Pavements
D6690-15
ASTM|D6690-15|en-US
Standard Specification for Joint and Crack Sealants, Hot Applied, for Concrete and Asphalt Pavements
Standard
D6690 Standard Specification for Joint and Crack Sealants, Hot Applied, for Concrete and Asphalt Pavements>
new
BOS Vol. 04.03 Committee D04
$
77.00
In stock
Abstract
This specification covers four types of joint and crack sealants of the hot applied type intended for use in sealing joints and cracks in Portland cement concrete and asphaltic concrete pavements. However, this specification does not address the properties required of sealants for use in areas of Portland cement concrete or asphaltic pavement that are subject to jet fuel or other fuel spillage such as vehicle and/or aircraft refuel and maintenance areas. The sealants shall be sampled and tested appropriately to examine their conformance with specified values of the following requirements: cone penetration; softening point; non-immersed and water-immersed bond properties; oven aged resilience; and asphalt compability.
Scope
1.1 This specification covers joint and crack sealants of the hot applied type intended for use in sealing joints and cracks in Portland Cement Concrete and Asphaltic Concrete Pavements.
1.2 This specification does not purport to cover the properties required of sealants for use in areas of Portland Cement concrete or asphaltic pavement subject to jet fuel or other fuel spillage such as vehicle and/or aircraft refuel and maintenance areas.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.