Standard
Historical
Last Updated: Jul 02, 2018
Track Document
ASTM D6677-07(2012)
Standard Test Method for Evaluating Adhesion by Knife
Standard Test Method for Evaluating Adhesion by Knife
D6677-07R12
ASTM|D6677-07R12|en-US
Standard Test Method for Evaluating Adhesion by Knife
Standard
D6677 Standard Test Method for Evaluating Adhesion by Knife>
new
BOS Vol. 06.02 Committee D01
$
77.00
In stock
Significance and Use
4.1 Coatings, to perform satisfactorily, must adhere to the substrates on which they are applied. This test method has been found useful as a simple means of assessing the adhesion of coatings. Although this method is a qualitative and a subjective test it has been used in industry for many years and can provide valuable information.
4.2 Other adhesion test methods may be useful in obtaining quantitative results. See D2197, D3359, D4541, and D7234.
4.3 The Performance Evaluation Scale (see 7.4, Table 1) is based on both the degree of difficulty to remove the coating from the substrate and the size of removed coating.
TABLE 1 Rating System
| Rating | Description |
| 10 | Coating is extremely difficult to remove; fragments no larger than approximately 0.8 by 0.8 mm (1/32 in. by 1/32 in.) removed with great difficulty. |
| 8 | Coating is difficult to remove; chips ranging from approximately 1.6 by 1.6 mm (1/16 by 1/16 in.) to 3.2 by 3.2 mm (1/8 by 1/8 in.) can be removed with difficulty. |
| 6 | Coating is somewhat difficult to remove; chips ranging from approximately 3.2 by 3.2 mm (1/8 by 1/8 in.) to 6.3 by 6.3 mm (1/4 by 1/4 in.) can be removed with slight difficulty. |
| 4 | Coating is somewhat difficult to remove; chips in excess of 6.3 by 6.3 mm (1/4 by 1/4 in.) can be removed by exerting light pressure with the knife blade. |
| 2 | Coating is easily removed; once started with the knife blade, the coating can be grasped with ones fingers and easily peeled to a length of at least 6.3 mm (1/4 in.). |
| 0 | Coating can be easily peeled from the substrate to a length greater than 6.3 mm (1/4 in.). |
4.4 This test method does not have a known correlation to other adhesion test methods (pull-off, tape, etc.).
Scope
1.1 This test method covers the procedure for assessing the adhesion of coating films to substrate by using a knife.
1.2 This test method is used to establish whether the adhesion of a coating to a substrate or to another coating (in multi-coat systems) is at a generally adequate level.