Standard
Historical
Last Updated: May 06, 2024
Track Document
ASTM D6511/D6511M-18
Standard Test Methods for Solvent Bearing Bituminous Compounds
Standard Test Methods for Solvent Bearing Bituminous Compounds
D6511_D6511M-18
ASTM|D6511_D6511M-18|en-US
Standard Test Methods for Solvent Bearing Bituminous Compounds
Standard
D6511/D6511M Standard Test Methods for Solvent Bearing Bituminous Compounds>
new
BOS Vol. 04.04 Committee D08
$
86.00
In stock
ASTM International
Significance and Use
3.1 These tests are useful in sampling and testing solvent bearing bituminous compounds to establish uniformity of shipments.
Scope
1.1 These test methods cover procedures for sampling and testing solvent bearing bituminous compounds for use in roofing and waterproofing.
1.2 The test methods appear in the following order:
|
| Section |
| Sampling | 4 |
| Uniformity | 5 |
| Weight per gallon | 6 |
| Nonvolatile content | 7 |
| Solubility | 8 |
| Ash content | 9 |
| Water content | 10 |
| Consistency | 11 |
| Behavior at 60°C [140°F] | 12 |
| Pliability at –0°C [32°F] | 13 |
| Aluminum content | 14 |
| Reflectance of aluminum roof coatings | 15 |
| Strength of laps of rolled roofing adhered with roof adhesive | 16 |
| Adhesion to damp, wet, or underwater surfaces | 17 |
| Mineral stabilizers and bitumen | 18 |
| Mineral matter | 19 |
| Volatile organic content | 20 |
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.