Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D6344-04
Standard Test Method for Concentrated Impacts to Transport Packages
Standard Test Method for Concentrated Impacts to Transport Packages
D6344-04
ASTM|D6344-04|en-US
Standard Test Method for Concentrated Impacts to Transport Packages
Standard
D6344 Standard Test Method for Concentrated Impacts to Transport Packages>
new
BOS Vol. 15.10 Committee D10
$
77.00
In stock
Significance and Use
This test method is intended to evaluate the ability of packaging to resist the force of concentrated impacts from outside sources, such as those encountered in various modes of transportation and handling. These impacts may be inflicted by adjacent freight jostling against the package in a carrier vehicle, by accidental bumps against other freight when loaded or unloaded from vehicles, by packages bumping against one another during sorting on conveyors or chutes, or many other circumstances.
This test method is intended to determine the ability of packaging to protect contents from such impacts, and to evaluate if there is sufficient clearance or support or both between the package wall and its contents.
Scope
1.1 This test method covers procedures and equipment for testing complete filled transport packages for resistance against concentrated low-level impacts typical of those encountered in the distribution environment. The test is most appropriate for packages such as thin fluted/lighter grade corrugated boxes or stretch-wrapped packaging.
1.2 The test result is a pass/fail determination, based on acceptance criteria previously established, and a record of the energy dissipated by the complete filled transport package during a low level concentrated impact.
Note 1—This test method discusses the conduct of the test from a prescribed height that either meets or does not meet specific acceptance criteria. It may be possible to conduct this type of testing using modified procedures that provide a numerical response. These might include an incremental test where the drop height (or mass) is increased until a specific failure occurs or an up-and-down or staircase procedure used to find the average height to failure.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.