Standard
Historical
Last Updated: May 06, 2024
Track Document
ASTM D6134/D6134M-07(2019)e1
Standard Specification for Vulcanized Rubber Sheets Used in Waterproofing Systems
Standard Specification for Vulcanized Rubber Sheets Used in Waterproofing Systems
D6134_D6134M-07R19E01
ASTM|D6134_D6134M-07R19E01|en-US
Standard Specification for Vulcanized Rubber Sheets Used in Waterproofing Systems
Standard
D6134/D6134M Standard Specification for Vulcanized Rubber Sheets Used in Waterproofing Systems>
new
BOS Vol. 04.04 Committee D08
$
77.00
In stock
ASTM International
Abstract
This specification covers unreinforced vulcanized rubber sheets made from ethylene propylene diene terpolymer (EPDM) or butyl (IIR), intended for use in preventing water under hydrostatic pressure from entering a structure. The tests and property limits used to characterize these sheets are specific for each classification and are minimum values to make the product fit for its intended purpose. Types used to identify the principal polymer component of the sheet include: type I - ethylene propylene diene terpolymer, and type II - butyl. The sheet shall be formulated from the appropriate polymers and other compounding ingredients. The thickness, tensile strength, elongation, tensile set, tear resistance, brittleness temperature, and linear dimensional change shall be tested to meet the requirements prescribed. The water absorption, factory seam strength, water vapour permeance, hardness durometer, resistance to soil burial, resistance to heat aging, and resistance to puncture shall be tested to meet the requirements prescribed.
Scope
1.1 This specification covers unreinforced vulcanized rubber sheets made from ethylene propylene diene terpolymer (EPDM) or butyl (IIR), intended for use in preventing water under hydrostatic pressure from entering a structure.
1.2 The tests and property limits used to characterize these sheets are specific for each classification and are minimum values to make the product fit for its intended purpose.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.