Standard
Active
Last Updated: Oct 20, 2020
Track Document
ASTM D5750/D5750M-95(2020)
Standard Guide for Width and Length of Pressure-Sensitive Tape
Standard Guide for Width and Length of Pressure-Sensitive Tape
D5750_D5750M-95R20
ASTM|D5750_D5750M-95R20|en-US
Standard Guide for Width and Length of Pressure-Sensitive Tape
Standard
D5750/D5750M Standard Guide for Width and Length of Pressure-Sensitive Tape>
new
BOS Vol. 15.10 Committee D10
$
64.00
In stock
Significance and Use
4.1 Conformance to this guide will reduce chances of misunderstanding between suppliers and users of pressure-sensitive tapes.
4.2 It is recommended that this guide be referenced where widths and lengths of pressure-sensitive tapes are stated, such as in contracts, orders, advertisements, and labeling.
Scope
1.1 This guide provides guidelines for widths and lengths of pressure-sensitive tape, including tolerances and labeling in the inch-pound and SI systems. It is not intended for tapes used for medical, surgical, or label stock purposes.
1.2 Units stated in the inch-pound system followed by a calculated unit in the SI system are to be regarded separately as standard and should not be interchangeable with units stated in the SI system. The units stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.