Standard
Historical
Last Updated: Jan 10, 2020
Track Document
ASTM D5206-13
Standard Test Method for Windload Resistance of Rigid Plastic Siding
Standard Test Method for Windload Resistance of Rigid Plastic Siding
D5206-13
ASTM|D5206-13|en-US
Standard Test Method for Windload Resistance of Rigid Plastic Siding
Standard
D5206 Standard Test Method for Windload Resistance of Rigid Plastic Siding>
new
BOS Vol. 08.03 Committee D20
$
77.00
In stock
Significance and Use
5.1 This test method is a standard procedure for determining windload resistance of rigid plastic siding under specified uniform static pressure difference. This typically is intended to represent the effects of wind loads on exterior building surfaces. The actual loading on building surfaces is quite complex, varying with wind direction, time, height above ground, building shape, terrain, surrounding structures, and other factors.
5.2 Design wind pressure is selected for specific geographical locations from wind velocity maps prepared by the National Weather Service or other sources. Refer to Annex A1 of Specification D3679 for additional detailed information relating to use of this test method for evaluation of rigid poly(vinyl chloride) (PVC) siding.
Note 2—In applying the results of this test method, note that the performance of rigid PVC siding is a function of installation, and the specimen may or may not truly represent the actual application. In service, performance will also depend on the rigidity of supporting construction, and on the resistance of other components to deterioration by various causes, to thermal expansion and contraction, etc.
Scope
1.1 This test method describes methods for testing and evaluating windload resistance of rigid plastic siding when fastened in accordance with Practice D4756.
1.2 The proper use of this test method requires a knowledge of the principles of pressure measurement.
1.3 This test method describes the apparatus and the procedures to be used to determine an average maximum sustained static test pressure, or ultimate test pressure values, or both, with static pressure applied uniformly to a specimen.
1.4 The values expressed in inch-pound units are to be regarded as the standard. The SI equivalents in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.