Standard
Active
Last Updated: Apr 24, 2019
Track Document
ASTM D5164-05(2019)
Standard Specification for Propylene Glycol and Dipropylene Glycol
Standard Specification for Propylene Glycol and Dipropylene Glycol
D5164-05R19
ASTM|D5164-05R19|en-US
Standard Specification for Propylene Glycol and Dipropylene Glycol
Standard
D5164 Standard Specification for Propylene Glycol and Dipropylene Glycol>
new
BOS Vol. 06.04 Committee D01
$
64.00
In stock
Abstract
This specification covers propylene glycol and dipropylene glycol for use in the preparation of surface coatings. The material properties enumerated, and apparent specific gravity shall be tested to meet the requirements prescribed.
Scope
1.1 This specification covers propylene glycol and dipropylene glycol for use in the preparation of surface coatings.
1.2 The following applies to all specified limits in this standard: for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 For specific hazard information and guidance, see the supplier's Material Safety Data Sheets.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.