Standard
Active
Last Updated: Dec 11, 2024
Track Document
ASTM D5094/D5094M-24
Standard Test Methods for Gross Leakage of Liquids from Containers with Threaded or Lug-Style Closures
Standard Test Methods for Gross Leakage of Liquids from Containers with Threaded or Lug-Style Closures
D5094_D5094M-24
ASTM|D5094_D5094M-24|en-US
Standard Test Methods for Gross Leakage of Liquids from Containers with Threaded or Lug-Style Closures
Standard
D5094/D5094M Standard Test Methods for Gross Leakage of Liquids from Containers with Threaded or Lug-Style Closures>
new
BOS Vol. 15.10 Committee F02
$
64.00
In stock
ASTM International
Significance and Use
5.1 These test methods are qualitative and used to indicate the integrity of the container and closure system in the distribution environment.
5.2 These test methods measure the ability of the container and closure system to prevent leakage when stored or transported upright, inverted, or on the side.
5.3 These test methods allow for comparison of container/closure designs of threaded and lug-style closures of similar or different materials, or different manufacturers. These tests are suitable for packaging development, engineering and tooling evaluations.
Scope
1.1 These test methods may demonstrate container/closure integrity with threaded or lug-style closures by the determination of gross leaks in rigid and semi-rigid containers (up to 4 L). Such tests may be used to indicate the ability of a liquid container to survive the distribution environment without leaking. These test methods may not be suitable to determine the leak resistance of containers intended for transport of hazardous materials.
1.2 Test Methods:
1.2.1 Test Method A, Shipping Container Vibration and Storage Test, covers the ability of a shipping container and its interior packaging to protect the contents from leakage after transportation induced vibration and high-temperature storage.
1.2.2 Test Method B, Shipping Container Vibration and Vacuum Chamber Test, is suitable for individual containers and is usually less severe than Test Method A. The advantage of Test Method B is the shortness of the test.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address the safety conserns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.