Standard
Historical
Last Updated: May 06, 2021
Track Document
ASTM D5078/D5078M-11(2016)
Standard Specification for Crack Filler, Hot-Applied, for Asphalt Concrete and Portland Cement Concrete Pavements
Standard Specification for Crack Filler, Hot-Applied, for Asphalt Concrete and Portland Cement Concrete Pavements
D5078_D5078M-11R16
ASTM|D5078_D5078M-11R16|en-US
Standard Specification for Crack Filler, Hot-Applied, for Asphalt Concrete and Portland Cement Concrete Pavements
Standard
D5078/D5078M Standard Specification for Crack Filler, Hot-Applied, for Asphalt Concrete and Portland Cement Concrete Pavements>
new
BOS Vol. 04.03 Committee D04
$
77.00
In stock
Abstract
This specification covers the standards for hot-applied crack filler proposed for use in filling cracks in asphalt concrete and portland cement concrete pavements. The filler shall be a compound that will effectively fill cracks in concretes and shall resist softening and pickup by vehicle tires at ambient summer temperatures. The fillers shall also comply with the requirements set for the safe heating temperature, softening point, cone penetration, resilience, and asphalt compatibility.
Scope
1.1 This specification covers hot-applied crack filler for use in filling cracks in asphalt concrete and portland cement concrete pavements.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.