Standard
Historical
Last Updated: Aug 06, 2012
Track Document
ASTM D5064-07
Standard Practice for Conducting a Patch Test to Assess Coating Compatibility
Standard Practice for Conducting a Patch Test to Assess Coating Compatibility
D5064-07
ASTM|D5064-07|en-US
Standard Practice for Conducting a Patch Test to Assess Coating Compatibility
Standard
D5064 Standard Practice for Conducting a Patch Test to Assess Coating Compatibility>
new
BOS Vol. 06.02 Committee D01
$
77.00
In stock
Significance and Use
In performing maintenance of a coating system, the new coating being applied must be compatible with the existing coating. While general guides exist which indicate compatibility of different generic types of coatings, differences in manufacturer’formulation and the condition of the in-place coating may affect compatibility.
Scope
1.1 This practice covers the procedures for testing coating compatibility when maintenance of an in-place coating system is being contemplated. It does not cover procedures for assessing the integrity of the existing coating to determine if it can be repainted, nor does it establish the compatibility of the maintenance coating system with the substrate or corrosion products. The practice is intended for use in the field.
Note 1 - Pass-Fail Criteria (for example, adhesion requirements) are not established by this practice. These should be established by the user or specifier with input from the supplier.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.